47 results for "Sabry Fayed"
Showing 1–20 · 1.89 seconds · RSS
-
Journal Article
Experimental Study on Effect of Recycled Reinforced Concrete Waste on Mechanical Properties and Structural behaviour of the Sandy Soil
Abstract In recent years, constructing natural aggregates as a base layer for the roads has increased. Natural resources will run out as long as human consumption of them continues. Recycled concrete aggregate (RC) has thus emerged as a substitute material for the building of road base layers…
-
Journal Article
Enhancing concrete support bearing strength with strain hardening cementitious composite (SHCC) layer: an experimental study
Abstract This study investigates the potential of Strain Hardening Cementitious Composite (SHCC) as a reinforcement layer to enhance the bearing strength of concrete supports, addressing the brittle failures often observed in conventional concrete under concentrated loads. Specimens were divided…
-
Journal Article
Shear performance of slender reinforced concrete beams: an analysis of various international standards
Abstract The performance and design of reinforced concrete, also known as slender beams are explained in the current study by a number of international codes. Slender beams are essential in modern construction because they preserve structural integrity while allowing for efficient material use…
-
Journal Article
Flexure Response of Isolated Square RC Footings Internally Reinforced by SMFs: Experimental and Numerical Investigations
Abstract This study investigates the flexural behavior of reinforced concrete (RC) footings supported on natural soil and internally strengthened using steel mesh fabrics (SMFs) as a novel alternative to conventional steel bars. Despite the widespread application of SMFs in structural retrofitting…
-
Journal Article
Enhancing the shear strength of reinforced concrete deep beams using thin-diameter near-surface mounted steel wires: an experimental study
Abstract This study investigates the effectiveness of near-surface mounted wire (NSMW) reinforcement as a shear-strengthening technique for reinforced concrete (RC) deep beams. Eleven specimens, including a control beam, were tested under three-point loading to evaluate the influence of vertical…
-
Journal Article Full text
Flexural Behavior of RC Beams with an Abrupt Change in Depth: Experimental Work
The most crucial components in the case of roofs with two levels or a variable floor height are variable depth beams. In order to investigate the flexural behavior of reinforced concrete (RC) beams with varying depths under static loads, experimental research was conducted. Under the four-point…
-
Journal Article
Behavior of Reinforced Concrete Circular Columns Subjected to Double Curvature Buckling Moment
Abstract This paper investigates experimentally and numerically structural performance of reinforced concrete (RC) circular column under double curvature buckling moment. RC circular columns are popularity embraced in RC structures not only owing to its esthetic, attractive appearance and easy for…
-
Journal Article
Interfacial Shear Behavior of Composite Concrete Substrate to High-Performance Concrete Overly After Exposure to Elevated Temperature
Abstract Basically, the interface shear strength between two concrete layers of varying ages must be sufficient to withstand the applied actions on the structure, specifically fire attack, which may cause the complete collapse of the composite structure. Thus, interfacial shear behavior was…
-
Journal Article
Structural Performance of Ferrocement Hollow Shear Walls Subjected to Lateral and Compressive Axial Loads
Abstract In this study, ten shear walls were experimentally tested to examine behaviour of ferrocement hollow shear walls subjected to axial and lateral loads. Ferrocement mortar (FM) was used to build eight walls, while normal concrete (NC) was used to build two controls. Walls were lateral…
-
Journal Article
Shear behavior of RC pile cap beams strengthened using ultra-high performance concrete reinforced with steel mesh fabric
Although pile cap bases of structures are the most significant element in the construction and one of the most difficult parts in strengthening applications, previous studies on this element, particularly strengthening, are quite limited. The most extensively utilized, highly efficient, and simple…
-
Journal Article
Improving Bond Performance of Near-Surface Mounted Steel Ribbed and Threated Rods in the Concrete
Abstract In this study, the experimental findings of twenty pull-out tests on the bond efficiency of threaded/ribbed steel rods used in near-surface mounting (NSM) are presented. On a groove (20 × 20 mm) that was slotted in one of the sides of a concrete block measuring 250 × 250 × 200 mm, a…
-
Journal Article Full text
Application of Engineered Cementitious Composites Reinforced with Orthogonal Welded Steel Mesh in Enhancing Axial Performance of Reinforced Concrete Walls: Experimental and Numerical Analysis
Reinforced concrete (RC) walls are designed to carry vertical and horizontal loads which may need to be rehabilitated and strengthened to enhance their load-bearing capacity due to increased loading demands, environmental factors, or lateral forces. This study proposes strengthening RC walls using…
-
Journal Article
Structural Performance of Ferrocement Beams Incorporating Longitudinal Hole Filled with Lightweight Concrete
Highlights This study is focusing on structural performance of ferrocement beams with lightweight cores reinforced with steel mesh fabric as a shear reinforcement. Lightweight core concrete with steel mesh fabric reinforcement was made either using lightweight aerated autoclaved brick aggregate…
-
Journal Article
Experimental study on using recycled polyethylene terephthalate and steel fibers for improving behavior of RC columns
In this research, the behavior of RC columns reinforced with recycled polyethylene terephthalate (PET) fibers and steel fibers (SFs) was experimentally investigated. The experimental work included testing of 8 columns with the dimensions of 150 × 150 × 1000 mm subjected to the axial loading up to…
-
Journal Article
Using Steel Meshes for Enhancing Bond Response Between Steel Bars and Steel Fibre Reinforced Recycled Aggregate Self-compacting Concrete
Abstract Centrally pull-out experiments were used to investigate the bond behaviour of steel rods implanted in steel fibre reinforced recycled aggregate self-compacting concrete (SSR). SSR, recycled aggregate concrete (RAC), and natural aggregate concrete (NAC) were all looked into. RCA replacement…
-
Journal Article
Effect of existing holes under the loading plate on local compressive strength of plain concrete blocks: An experimental and numerical study
The bearing strength of concrete is an important design consideration for structural safety. Base plates for columns are necessary in order to transfer forces to concrete supports. In order to place the post-installed anchorages that hold the base plate to the footing, holes must be bored beneath…
-
Journal Article
Prediction of RC T-Beams Shear Strength Based on Machine Learning
Abstract The contribution of shear resisted by flanges of T-beams is usually ignored in the shear design models even though it was proven by many experimental studies that the shear strength of T-beams is higher than that of equivalent rectangular cross-sections. Ignoring such a contribution result…
-
Journal Article Full text
Seismic Resistance of RC Corner Eccentric Beam-Column Sub-assemblages
An experimental investigation studied performance of reinforced concrete (RC) corner beam-column connection (BCC) subjected to cyclic loading. Each BCC consisted of upper, lower column and two beams; one of them was free end (A) while the other was fixed end (B). The cyclic loading was applied on…
-
Journal Article
Numerical assessment of failure load and soil–footing contact stress distribution for concrete foundations on cohesionless soil
Abstract The behavior of isolated reinforced concrete (RC) footings is strongly influenced by the interaction between the footing and supporting soil, which governs settlement, load capacity, and contact stress distribution. Classical analytical solutions often overestimate edge stresses and fail…
-
Journal Article
Experimental and numerical investigation on basaltic soil under RC square footings
Abstract The accurate ability to predict the distribution of contact stress under reinforced concrete (RC) footings is important for the safety and serviceability of shallow foundations. Conventional analytical models idealizing the footing as rigid and soil as homogenous fail to capture the stress…